Owner’s Manual
Model
DGWH4031
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this heater. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
7204830200R03
Welcome & Congratulations
Thank you and congratulations for choosing to purchase an electric
heater from Dimplex, the world leader in electric heaters.
Please carefully read and save these instructions.
CAUTION: Read all instructions and warnings carefully before
starting installation. Failure to follow these instructions may result
in a possible electric shock, fire hazard and will void the warranty.
Please record your model and serial numbers below for future
reference: model and serial numbers can be found on the Model and
serial number Label of your heater.
Model Number
Label
Serial Number
NO NEED TO RETURN TO THE STORE
Questions with operation or assembly? Require Parts Information?
Product under Manufacturer’s Warranty?
Contact us at:
OR
For Troubleshooting and Technical support
Toll-Free 1-888-DIMPLEX (1-888-346-7539)
Monday to Friday 8:00 a.m. to 4:30 p.m. EsT
Please have your model number and product serial
number ready. (see above)
3
IMPORTANT INSTRUCTIONS
When using electrical appliances, the heater has been dropped or
basic precautions should always
be followed to reduce the risk of
fire, electric shock and injury to
person, including the following:
damaged in any manner. Return
heater to authorized service
facility for examination, electrical
or mechanical adjustment or
repair.
① Read all instructions before
using this appliance.
⑥ Do not use outdoors.
② The heater is hot when in use.
To avoid burns, do not let bare
skin touch hot surfaces. The trim
around the heater outlet becomes
hot during heater operation.
Keep combustible materials, such
as furniture, pillows, bedding,
papers, clothes, and curtains at
least 3 feet (0.9m) from the front
of the unit.
⑦ The heater is not intended for
use in bathrooms, laundry areas
and similar indoor locations.
never locate heater where it may
fall into a bathtub or other water
container.
⑧ Do not run the cord under
carpeting. Do not cover cord with
throw rugs, runners or the like.
Arrange cord away from traffic
area and where it will not be
③ Extreme caution is necessary
when any heater is used by or
near children or invalids and
whenever the unit is left operating
and unattended.
tripped over.
⑨ To disconnect the unit, turn
the controls off, then remove the
plug from the outlet.
④ always unplug the heater
when not in use.
⑩ Connect to properly grounded
outlets only.
⑤ Do not operate any unit with
a damaged cord or plug, or if the
heater has malfunctioned, or if
⑪ Do not insert or allow foreign
4
IMPORTANT INSTRUCTIONS
objects to enter any ventilation
or exhaust opening as this may
cause an electric shock or fire, or
damage to the heater.
cord directly into appropriate wall
receptacle.
⑯ This heater includes a visual
alarm (red light) to warn that parts
of the heater are overheating. If
the red light turns on, immediately
turn heater off and inspect for
any objects on or adjacent
to the heater that may cause
high temperatures. Do noT
oPERaTE WHEn RED LIGHT Is
on.
⑫ To prevent a possible fire, do
not block air intake or exhaust
in any manner. Do not use on
soft surfaces, like a bed, where
openings may become blocked.
⑬ all electrical heaters have
hot and arcing or sparking parts
inside. Do not use in areas where
gasoline, paint, or flammable
liquids are used or stored, or
where the unit will be exposed to
flammable vapors.
⑰ Always use a certified
electrician should new circuits or
outlets be required.
⑱ Disconnect power supply
before performing any cleaning,
maintenance or relocation of the
unit.
⑭ Do not modify the heater.
use it only as described in
this manual. any other use
not recommended by the
manufacturer may cause fire,
electric shock or injury to persons.
⑲ When transporting or storing
the unit and cord, keep in a
dry place, free from excessive
vibration and store so as to avoid
damage.
⑮ This heater is not intended for
use with an extension cord. Plug
SAVE THESE INSTRUCTIONS
5
IMPORTANT INSTRUCTIONS
grounding Instructions
Figure 1:
Plug and outlet
configuration for 240
Volt, 20 amp circuit
Plug
This heater is for use on 240
Volts. The cord has a plug as
shown on Figure 1. no adapter
should be used with this unit. The
type outlet is a 240 Volt grounding
outlet. When properly installed,
it provides a ground connection
through the cord to the heater to
protect the operation from
outlet
electric shock.
Ground
6
Heater Installation
HEATER LOCATION AND
CLEARANCES
FIgURE 2
ouTsIDE WaLL
The heater is intended for flat
use on a hard floor, table top,
desk or on shelf, and the like, or
suspended on a wall or ceiling
by means of provided hanger
bracket.
When suspended from wall or
ceiling, heater should be located
along outside walls to provide
perimeter air circulation.
use of the hanger bracket allows
the unit to be rotated approx 45°
in each direction from centre,
and tilted in a range of 45° while
suspended from a wall or ceiling.
The discharge air should wipe the
walls without blowing directly on
them. (Figure 2)
! NOTE: The hardware for
mounting the hanger bracket to
the wall or ceiling is not included.
If heater is to be tilted on
horizontal axis after mounting -
ensure a minimum clearance of
26.5 inches (67 cm) between floor
and bottom of heater. also, when
mounted to ceiling, ensure a
minimum clearance of 3.5 inches
(9 cm) from ceiling to top of
CAUTION: When turning
and/or tilting the heater do not
block the exhaust opening.
The following steps are shown in
Figure 3.
heater. Ensure the air discharge
is parallel to or away from walls.
1. Locate a stud or other
suitable support and install
hanger bracket on wall or
ceiling. select a location
where the control knob can
be easily reached.
INSTALLATION WITH WALL/
CEILINg HANgER BRACkET
! NOTE: To prevent personal
injury always use a licensed
electrician to install new outlets or
circuits.
2. Insert carriage bolt into
square opening of heater
7
Heater Installation
handle.
Figure 3
Hanger
Bracket
3. slide spacer over the carriage
bolt shaft and insert in
T-Handle
hanger bracket opening and
hold them in position.
Lock Washer
4. slide lock washer and thread
on T-Handle onto carriage
bolt, turning to tighten.
spacer
Carriage
Bolt
air In
air out
Hanger Bracket Mounting Options
8
Operation
Setting the Thermostat
Figure 4
1. Before connecting or
disconnecting plug, turn
knob fully counterclockwise.
(Figure 4)
off
Low
High
2. Heater is equipped with
a thermostat. To adjust
temperature to your individual
requirements, turn thermostat
control knob clockwise all
the way to turn heater on.
The yellow power light will
illuminate (Figure 5). When
room reaches desired
Thermostat control knob
(shown in off position)
Figure 5
Yellow light
Power on
En Marche
Encedido
temperature, turn thermostat
knob counterclockwise until
you hear click. Leave in
this position to maintain
room temperature at this
setting. For additional heat,
turn clockwise until you
over Temp
surchauffe
Temperatura
Excesiva
Red light
hear click again and heater
will turn on. To shut heater
off turn thermostat knob
counterclockwise all the way.
The yellow power indicator
light will turn off.
! NOTE: Heater is equipped
with a fan delay to dissipate
residual heat from the element.
Heater fan will run for a brief
period after heater has reached
room temperature.
9
Maintenance and Cleaning
To clean the exterior surface,
use a solution of water and mild
detergent, apply with damp
sponge. Wipe dry with a dry
cloth. DO NOT plug heater into
outlet until it has dried thoroughly.
WARNINg: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of fire, electric
shock or damage to persons.
CAUTION: allow at least
30 minutes for the heater to
cool before attempting any
maintenance or cleaning.
Warranty
Dimplex Electric Heaters are tested
and inspected prior to shipment and
are guaranteed free from defect to the
purchaser of each new product. any part
which proves to be defective in material
or workmanship under normal use within
one year will be repaired or replaced
without charge. The Company will not
be responsible for any expense incurred
for installation, removal from service, or
transportation costs. any such defect
should be brought to the attention of the
Dealer where the product was purchased
and is authorized to repair or replace
within the terms of this warranty.
refund the purchase price thereof.
The owner/user assumes all other risks,
if any, including the risk of any direct,
indirect or consequential loss or damage
arising out of the use of or inability to use
the product.
The warranty will not apply if, in the
sole judgment of the Company, damage
or failure has resulted from accident,
alteration, misuse, abuse, incorrect
installation, or operation on an incorrect
power source.
The foregoing is in lieu of all other
warranties expressed, implied, or
statutory, and the Company neither
assumes, nor authorizes any person to
assume for it any other obligation, or
liability in connection with said product.
The Company’s only obligation under this
warranty will be at its sole option to repair
or replace any part proving defective or to
10
Replacement Parts
Fan Blade . . . . . . . . .1900010022RP
Motor Kit . . . . . . . . . .2000020022RP
Fan Delay . . . . . . . . . . .00033002RP
Thermostat . . . . . . . . . .13678001RP
Cutout . . . . . . . . . . . . . . .0009112RP
Knob - Clear . . . . . . . . .02210011RP
Hanger Bracket . . . . .1005900168RP
Dimplex North America Limited
1367 Industrial Road
Cambridge on
Canada n1R 7G8
© 2012 Dimplex north america Limited
11
|