Glen Dimplex Home Appliances Ltd Ventilation Hood DIH900 User Manual

Designer Island Hood  
DIH900  
Installation & User’s instructions  
 
Fig.5  
Fig.6  
B
I
P
M
E
A
B
1A  
Fig.8  
Fig.7  
P
A
B
C
E
D
F
1B  
G
B
C
E
D
A
 
3
Your new Belling Island Hood  
Dear Customer  
These instructions are designed to help you know your new cooker hood quickly and to  
achieve the best possible results.  
It is most important that this instruction book should be retained with the appliance for  
future reference. Should the appliance be sold or transferred to another owner, or  
should you move house and leave the appliance, always ensure that the book is  
supplied with the appliance in order that the new owner can be acquainted with the  
functioning of the appliance and the relevant warnings. Please ensure that you have  
read the whole instruction book before using the appliance and that you follow the  
recommendations.  
Warnings  
These warnings are provided in the interest of safety. Please read carefully before  
installing or using the appliance.  
1. Keep children away from the product.  
2. Any installation work must be undertaken by a competent person and installed in  
accordance with the current IEE regulations.  
3. It is dangerous to alter the specification or modify the product in any way.  
4. If this appliance is to be connected to a ventilation system, it should not be joined  
with a ventilation system from any other appliance.  
5. The product should be serviced by an authorised Belling service engineer and only  
genuine Belling spare parts should be used.  
• General information  
This instruction book applies to various models and your model may not have all  
functions described:  
This cooker hood is guaranteed and will give lasting service. The guarantee is only  
applicable if the hood has been installed in accordance with these instructions.  
The cooker hood has been designed for use fixed directly to the ceiling.  
The hood can be used to extract odours to the outside or to recirculate the air within the  
kitchen after passing through a cleansing charcoal filter. Charcoal filters are supplied  
as an optional extra, please phone Belling Spares department on 0844 815 3745 and  
quote part number DCH900004.  
The hood is convertible to either function.  
Belling disclaims any liability for any damage or injury caused as a result of not  
following the installation instructions.  
Warning: This hood is designed for domestic use only.  
When used in the extraction mode the cooker hood ducting must not be connected to a  
flue which is used for exhausting fumes from appliances supplied with energy other  
than electric, such as a central heating flue or a water heater flue.  
If the room where the cooker hood is to be used contains a fuel burning appliance such  
as a central heating boiler, then its flue must be of the room sealed or balanced flue  
4
 
type. If other types of flue or appliances are fitted, ensure there is adequate ventilation  
in the room.  
All installations must comply with local authority requirements for the discharge of  
exhaust air.  
• Positioning  
When installed above a cooking appliance the distance between the surface of the  
appliance hotplate and the lower grill of the hood must not be less than 65cm (25½”).  
This appliance is suitable for ceiling heights of approximately 236cm (7’9") and 273cm  
(9’0") depending on the installation. If you have a ceiling greater than this height  
please ring our spares department on 0844 815 3745 for the tall ceiling kit (see  
Optional Extras).  
If the cooker hood is installed for use above a gas appliance then the provision for  
ventilation must be in accordance with the Gas Safety (Installation and Use)  
Regulations and the relevant building regulations.  
Warning: The fan motor of this cooker hood incorporates a thermal cut-out which will  
operate if the cooker hood is installed below the minimum recommended height or the  
motor overheats. If the cut-out operates. Switch off the cooker hood and allow the  
motor to cool, the cutout will then reset itself.  
• Unpacking  
Care should be taken when unpacking the cooker hood to ensure that the following  
parts are not discarded.  
- Components  
The hood consists of:  
1 hood body A complete with controls and lights  
1 upper mounting structure B.  
1 lower mounting structure C.  
1 complete telescopic flue E.  
1 connecting flange F.  
1 air deflector M.  
1 bag containing:-  
2 x G screws  
14 x I screws  
3 x P screws  
Fixing template  
Instructions and documents  
• Installation Instructions  
Mounting the Cooker Hood  
A) With the aid of the paper template placed with the arrow corresponding  
to the cooker hood control side, mark the centre of the holes and drill 8  
mm diameter (Fig.3)holes to suit location. Use 4 or more fixing holes according to the  
location.  
5
 
Note: Depending on the location and the construction of ceiling, it may be necessary  
to use a more substantial method of fixing, e.g. nuts and bolts, rather than normal  
self-tapping or wood screws.  
B) Mount the connector flange F above the cooker hood ventilation kit,  
using the G screws (Fig. 4).  
Couple the lower mounting structure C with the cooker hood A using the 6  
screws I (Fig. 4).  
Connect a flexible air discharge tube (not supplied), of 120mm diameter, to the F  
flange (Fig. 6)  
Recirculating mode only : fix the air deflector M (fig. 6) to the upper mounting structure  
B using the appropriate screw P.  
C) Mount the cooker hood supporting the chimney flues and inserting  
the lower mounting structure to the upper mounting structure, confirm the height and fix  
the 2 structures together with the appropriate 8 screws I (fig. 5).  
Recirculating mode only : connect the flexible tube previously mounted on the F  
flange to the deflector M (fig. 6)  
External exhaust mode : connect the discharge tube previously mounted to  
the F flange to the external discharge pipe.  
Internal Exhausting  
Charcoal filters are used to purify the air which will be recycled into the room. The filters  
cannot be washed or regenerated and must be replaced every 4 months.  
The charcoal filters are supplied as an optional extra, please phone Belling Spares  
department on 0844 815 3745 and quote part number CHT28.  
Saturation of the activated charcoal depends on more or less extensive use of the  
hood, the type of kitchen and the regularity of cleaning the grease filter. The air is  
recycled into the room through the slots in the flue E.  
• Electrical Connection  
Before connecting to the mains supply ensure that the voltage is as stated on the rating  
plate inside the cooker hood.  
Warning: This appliance is fully insulated and must not be earthed.  
The appliance comes with a 2 core mains cable and should be permanently connected  
to the electricity supply via a double pole switched fused spur outlet with a minimum  
contact clearance of 3mm in both poles.  
Installation must comply with the latest IEE regulations and must be carried out by a  
competent person.  
The cooker hood must be protected by a 3-amp fuse.  
Use and Maintenance  
If your model has mechanical controls it is advisable to switch the cooker hood on a  
few minutes before cooking starts and that it be left on for about 15 minutes after  
cooking is completed to exhaust all the odours.  
If your model has luminous controls, switch on a few minutes before cooking starts  
and activate the automatic stop timer to allow the cooker hood to continue functioning  
for about 15 minutes after cooking is completed to exhaust all the odours.  
On the front of the hood there are (Fig. 8):  
6
 
1A) LUMINOUS  
A = LIGHT  
B = OFF  
C = SPEED I  
D = SPEED II  
E = SPEED III  
F = AUTOMATIC STOP TIMER - 15 minutes  
The “Automatic stop timer” allows the hood to continue functioning for 15 minutes at the  
operating speed set at the time this function is activated.  
1B) MECHANICAL  
A = LIGHT  
B = OFF  
C = SPEED I  
D = SPEED II  
E = SPEED III  
G= MOTOR WORKING indicator  
Good functioning of the hood depends on the regularity with which maintenance  
operations are carried out, in particular of the anti-grease filters and the activated  
charcoal filter. The anti-grease filters have the function of holding back grease  
particles suspended in the air, and are thus subject to clogging with time depending on  
the frequency of use of the appliance.  
Clean the filters every 2 months, carrying out the following operations:  
- Remove the filters from the hood and wash them with warm soapy water.  
- Rinse in abundant lukewarm water and leave them to dry.  
- The filters may also be washed in the dishwasher.  
The aluminium panels may be subject to colour alterations due to many washes. This  
is natural over time and will not affect the performance of the appliance.  
In case of inobservance of the washing instructions there is a risk of the filter catching  
fire.  
Frequently clean off all the deposits on the fan and other surfaces, using warm soapy  
water.  
Replacement of the Halogen Lamp  
WARNING!! DISCONNECT FROM MAINS BEFORE CHANGING LAMP  
Note: The bulb is not covered by the guarantee as it is a consumable item.  
Lamps are available from our spares department, please ring 0844 815 3745 and  
quote part no.CHT265B  
To replace the halogen lamp, carefully prise off the cover and remove complete with the  
lamp glass.  
Put in the new lamp taking care not to touch the glass with fingers and replace lamp  
glass and cover.  
Do’s and Don’ts  
Do take extra care when frying  
Do clean grease filters and hood regularly  
7
 
Do change charcoal filters regularly  
Don’t leave naked flames under the cooker hood  
Don’t leave frying pans unattended during use as overheated fat may catch fire  
Don’t flambé cook under the cooker hood  
Don’t try to check the filters when the hood is in operation.  
Don’t touch the lamp after prolonged use of the appliance.  
If your cooker hood doesn’t work  
Check the power supply  
Is the hood switched on?  
Has the hood become too hot and switched itself off?  
If hood is still not working call for service  
This appliance conforms to the following EEC directives  
Low Voltage Directive  
73/23/EEC  
93/68/EEC  
Electromagnetic Compatibility  
89/336/EEC  
92/31/EEC  
93/68/EEC  
8
 
Optional extras  
Please quote the following part number if you require a ducting or tall ceiling kit.  
Filter  
DCH900004  
Ducting Kit Short  
Ducting Kit Long  
Tall ceiling kit Stainless Steel  
Tall ceiling kit Aluminium  
CHIM100004 (1m)  
CHIM100004A (3m)  
DIH900002  
DIH900003  
Calling for Service  
Please contact your retailer in the first instance. If you experience difficulty contact Belling  
Appliances (After Sales Division)  
Remember that you may be charged for the visit (even during the guarantee period) if  
nothing is found to be wrong with the appliance, so always check the instructions in case  
you have missed anything.  
Belling Appliances After Sales Division (Service)  
Tel: 08444 815 3746 (all calls will be charged at local rate)  
Before contacting a service agent, please note the following details about your cooker:  
Model Number  
________________________________________________________  
Serial Number  
________________________________________________________  
Date of Purchase  
______________________________________________________  
Also note your Postcode  
________________________________________________________  
In order to provide a complete service history for your cooker please ask the service engi-  
neer to record the appropriate details in the chart below.  
Date  
Nature of Fault  
Parts replaced or repaired  
Authorised stamp or  
signature  
9
 
10  
 
11  
 
BellingAppliancesLtd.  
Stoney Lane, Prescot, Merseyside L35 2XW  
PART No. DIH900001/01/02  
 

Eiki Flat Panel Television PLD 42UE User Manual
Eizo Computer Monitor F520 User Manual
Electro Voice Musical Instrument Amplifier GS 2000A User Manual
FEIN Power Tools Drill DS 648 User Manual
Fellowes Paper Shredder MS 450Cs User Manual
Fisher Price Automobile Parts V4599 User Manual
GE Cooktop JGP326BEV User Manual
Giant Water Pump GP7132 User Manual
Global Machinery Company Work Light VEC156 AU User Manual
Goodman Mfg Air Conditioner Air Conditioning and Heat Pump Packaged Units User Manual